Titanium alloy Ultrasonic booster match for Rinco C20-10 Rinco 20 kHz booster

The Ultrasonic Booster like the gear in a car, where as the lowest is first gear and so forward. This also means that the higher ultrasonic booster you put on the more power is needed behind to start it, so even if the ultrasonic horn can take more gain (higher ratio), if you ultrasonic generator is not powerfully enough you will not be able to start it up and the Ultrasonic generator will go into overload.The success of an ultrasonic plastics assembly application is dependent on the required force, time, and velocity factor to obtain the correct energy level. The ultrasonic velocity factor is obtained by using the correct ultrasonic horn and ultrasonic booster combination to provide the optimum amplitude for the type of plastic, size of part, and type of assembly to be per-formed. Since it may be technically impractical to design the correct amplitude into the ultrasonic horn because of its shape, ultrasonic boosters are used to either increase or decrease the amplitude at the ultrasonic horn face to transmit the required energy to the joint interface.

The Ultrasonic booster is a one half-wavelength long resonant section made of aluminum or titanium. It is mounted between the Ultrasonic converter and the Ultrasonic horn, and modifies the amplitude of vibration applied to the Ultrasonic horn.

Choosing the Correct ultrasonic Booster: When selecting a ultrasonic booster to be used for an application, it is recommended to use the lowest gain ratio possible that will provide acceptable application results for correct amplitudes values. This will help to operate the ultrasonic horns at lower fatigue levels, which increases tooling reliability.To provide amplitude change, the ultrasonic booster will have different diameters and mass on either side of its center or nodal point.

An amplitude increasing booster has a smaller mass at the end attached to the ultrasonic horn, while an amplitude decreasing ultrasonic booster has a greater mass at the end attached to the ultrasonic horn.

HC-SONIC specializes in ultrasonic technology and its related components for numerous industries. It offers a wide range of state-of-the-art, low maintenance welding machines assembled with high quality components and compliant with current ISO standards.

Contact our highly qualified technical department if you have any doubts regarding the proper machines for any practical request.

Rinco ultrasonic transducers as follows:

C20-10/ C20-12

C35-10/ C35-11/ C35-12/ C35-13

C70-2

Also we can supply all generator for driving the above transducers.

Features

• Poreless, high-density piezoceramics
• Mechanically very strong and stable.
• High mechanical quality factor
• Excellent electro-acoustic conversion efficiency
• Minimal thermal dissipation and power losses
• High output amplitudes

Competent advice is the cornerstone of any successful project. Thanks to our technical consultants’ extensive specialist knowledge and many years’ experience, they are able to analyse your application and develop the best possible solution. We will test your sample material in detail and then make proposals for the design of your mouldings.

It is best if you contact us early in the first phase of a project because the earlier we get involved, the quicker we will find a solution for you. You are also very welcome to visit us and see for yourself the passion with which testing and experimentation goes on in our laboratory. Our technical applications consultancy is free of charge - you only pay for the solution, not how we arrive at it!